If you have your Pi hooked up to the network then you should be able to browse the devices on the network and find one titled RetroPie. Once you have changed all of your settings you can choose Finish from the main menu and say Yes to rebooting.Īt this point you should have a fully functional Pi and should be able to copy roms to it either over the network or via a USB drive. Some people will warn you against this, because it can damage your pi, however if done properly, you shouldn't have a problem. An optional step is to overclock your Pi. From here you can change the Timezone as well as the Keyboard Layout. The last suggested step that you really need to perform is to change the Internationalisation Options. You may find that you need more, depending on what you end up emulating. Memory split allows us to give more memory to the GPU so that our emulated games can run more smoothly. After you have set that, go back to Advanced Options and set the Memory Split to a minimum of 256 for a Pi2 and 64 for an original Pi. Overscan is essentially the black bars around what is being displayed from the Pi. Next, if you go to Advanced Options then you can enable or disable the Overscan. This will allow RetroPie access all of the space allowed on your MicroSD card. The first step you want to do is to Expand Filesystem. This will bring you to a rudimentary menu that allow you to customize your Pi. Capitalizations are important, so be sure to type everything as shown. Once your are at the command line interface (CLI), you need to type sudo raspi-config. A message will pop-up telling you when to press any key. If you are on RetroPie version 3 or higher you will automatically get put back into Emulation Station if you do not hit any keys on the keyboard within 5 seconds. To do this, you can hit your start button and choose quit and then choose quit emulation station. Once you have your initial input device setup, you will need to quit emulation station. If you get to a button/key that your controller doesn't have, you can just hold down any button and it will be skipped. At this point you can choose to setup a keyboard or controller first, but you can always setup others. Once the Pi is booted up, you should be in Emulation Station and it should be asking you to setup an input device. I've run into issues before with the Pi displaying on my TV, so I always turn my TV on and have it set to the right input before I turn on the Pi. Once the MicroSD card is finished being prepared, you can put it in your Pi and plug in the power cord. This should then write the entire contents of the RetroPie image to your MicroSD card. Choose the device letter within the device dropdown and then click write. In the case of using Win32DiskImager, you should be able to browse for the image file using the blue folder icon. Once you have your tool of choice downloaded, you can open it up and write the RetroPie image to your MicroSD card. If that's too much, you can try ApplePi Baker. If you are on a mac, it looks like you can just use the terminal in place of Win32DiskImager. If you are on a windows PC, you can download a tool called Win32DiskImager. There's separate downloads for if you are using a Pi2 or a Pi1. First, you have to download Retropie from.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |